I have already optimized energy for high performance.I installed DriverBooster Pro 8 to install other Drivers.I already reset my PC more than 3 times.Therefore my project is not working well. After restoring my PC, the DRIVER was automatically installed and now I only have 2048 Buffer Size available and the SAFE mode. I had to reset my PC, and before I did it,I had up to 8192 in the BUFFER SIZE and the EXTRA SAFE mode. I have the UMC 202HD interface and the STUDIO ONE 5 for DAW. specifically disabling the “allow computer to turn off this device to save power” part. Lastly, someone mentioned the power settings for these USM roots. I have seen others say that disabling 3.0 USB controllers fixes the issue when its related to the mobo. I did not have to do this, but you might have a different situation. Go to your device manager and disable all devices that isnt your audio interface. ![]() Now, if the samples before and after that “pop” are lower, that “gap” is going to only make the difference more noticeable.Īt any rate, time for more troubleshooting try some of these: It will just go on ahead, and empty what is in the buffer, which when there is a “pop” thats when the buffer was empty. If a sample is dropped because of starvation, that sample rate isnt going to wait. Well since the pops are a result of gaps, it actually is pretty sensible that a change in frequency of the source would change the frequency of the “pop”.
0 Comments
Leave a Reply. |